ADVERTISEMENT

How to install a water tank on the roof step by step

This course is perfect for those who don’t have any prior knowledge of the subject.

A water tank can be a great way to improve your quality of life, and it is easy to install and maintain a steady supply of water. A professional can help you install your water tank if you are not familiar with it.

Installation of water tanks

Two steps are required to install water tanks. The first step involves fixing the tank to the ground. The tank is connected to the domestic water system via a supply line, and the tube contains a special valve that allows the tank to be filled. This, along with the float, shut off water flow when the tank is full.

The reinforced manifold is located at the outlet point. Here you will find filters and other useful accessories. You will need to have some knowledge to connect and assemble the parts of the kit to ensure that it works properly.

Before buying a water tank, here are some recommendations.

Choosing a water tank that meets your household’s water requirements is essential. Water tanks come in different sizes. If the household is two people, a 450-liter tank will suffice, and a 2500-liter tank is best for a household with ten people.

– Perform an analysis of the room to determine the best place for the tank.

It is not recommended that the tank be placed flush with the ground. Water tanks have a unique base, which must be placed on a pallet. This base must be placed at least 2 meters above the highest water outlet, ensuring excellent water pressure.

Follow the steps below to install a water pump

1.- Water can be pumped through the filling valve. It is located on top of your water tank. Could you attach it to the tank from the inside? The water outlet should always be parallel to tank walls. Screw in the plug. You will need a reducer piece if the plug is less than 1/2 inch. After this, connect it to the pipe and then to the 90o bow. You can use either a traditional melter or a hose depending on what you have. Attach the 90o sheet to the water supply line.

2.- Place the float in your valve. This accessory stops the water from rushing. The float activates the valve to cut off the water when the water level reaches its maximum. This will work by adjusting the float to the correct position and ensuring it is at the proper height. Adjust the screw on the top to allow the float to move freely until it reaches its maximum point.

3.- Connect the reinforced multiple connections to the outlet point, which regulates the water outlet. The air jug is located in the top hole of your manifold, and it removes air bubbles from the pipe and stops them from reaching the tank. Install the check valve. Be sure to refer to the hydraulic network, not the water tank.

4.- Although the standard filter can be used as an optional option, it is the best match for your water tank because it removes any physical impurities. It can stop particles as small as hair from entering the water, protecting you and your family’s health. This can be found in the input jack.

Download

Leave a Comment

Engineering Books